Range of industrial variable frequency drives (VFD)

Control

         Technology has evolved. The electrical system or unit (Unit) has evolved rapidly. Engine. Rotates at a constant speed. Variable speed. Fast and accurate. Magnetic torque and speed, if necessary. Therefore, the drive system or unit (s) function and a good job. It is justified in this field is very important. More efficient production system.

variable frequency drives (VFD)  features they need.

            The air conditioning is available in a variety of industrial sectors. It should contribute to the role of working to improve quality. It also saves energy. 

Torque.

           Accelerate choice of units of torque. Motor control the flow. And low-end torque. It can control the ratio of the load. Download speed is suddenly changed. Loaded everything. And running torque. If the increase or decrease the torque. What activities. 

Process Control 

      You have the ability to output back in control, show that the feedback system. There are methods that require deviations from the requirements, a response to the IP-and software equipment for the starting point. Advantage of using the power supply. Get to "Auto / Manual" open the possibility that repeated. In addition, the installation, configuration and installation in the factory. Lead to completely manage the complex. Inverter is set according to the requirements of good reviews.

Slip Compensating

     Torque and speed. Or a slip of the tongue, which is related the velocity of the stator automotive industry here. The relationship between the slip of the motor load is very important because the device will automatically increase the output frequency is still active. Without the need to reduce the speed to compensate for the amount of slippage in relation to the height of the load increases. Maximizing the value of the load of the leaves is an appropriate and effective improvement of economic conditions. Speed. Improve the performance of the torque.

Speed ​​and direction 

        Speed ​​control function, he added. I am slow to react to the series. The motor rotates in the direction corresponding to the flow. I have the ability to run the engine speed to determine the direction and speed of the engine. He compares the engine. There are programs to improve the speed and direction to determine the motor. I have the best start. Desire to continue in control.

       You can also change the number of motors is controlled by a single team or put a new motor was installed in the system. Motor controls to work with others, especially if the Motor does not have the same type and size the same.

Overload Protection

    Improved design protects the engine. Overload as well as the standard. If the congestion of the heat. Temperatures motor. When operating under full load. The costs are higher in about 70-80% of the control (travel costs). 

Auto Economize
     This is to control the flow of the stator with a model of energy. This allows you to save energy costs. The monitor automatically to save energy. Compare to support the current position of power while working. Protection against overload. 

Braking
      Is the use of "brake" to stop the motor during operation. Invented, and how the level of DC and the time to develop the engine torque to stop, take the "Off Ramp" you as soon as possible to stop the engine. Input voltage DC motor. To determine when the engine stops instead. If you are not braking to the outside. You can stop in an emergency. 


Frequencies 
      Control of mechanical resonance frequencies are usually published. I caused by "fluctuations in the frequency and the rapidly changing case of a continuous oscillation. This can cause mechanical damage to the site. Therefore, development programs, turns on the windshield constantly in the process of resonance. You can increase or decrease the frequency. frequency changes rapidly.


Fault
      There are programs that record of failure and the role of what is happening. In addition, you can tell what the package with aluminum foil. The analysis of the parameters to determine the parameters in groups. And when the blade in the position, the motor will start automatically. Each time, the role that becomes very long. This saves time and increases productivity.